CLEARANCE WARNING BUZZER INSTALLATION


  1. INSTALL CLEARANCE WARNING BUZZER


    1. Engage the clamp to install the clearance warning buzzer.

    2. Connect the connector.

  2. INSTALL RADIO RECEIVER ASSEMBLY WITH REGISTER (w/o Navigation System)


    1. Connect each connector.

    2. Engage the 7 clips.

    3. Install the radio receiver assembly with register with the 4 bolts.

      Torque:
      4.9 N*m  { 50 kgf*cm, 43 in.*lbf }

  3. INSTALL MULTI-MEDIA MODULE RECEIVER ASSEMBLY WITH REGISTER (w/ Navigation System)


    1. Connect each connector.

    2. Engage the 7 clips.

    3. Install the multi-media module receiver assembly with register with the 4 bolts.

      Torque:
      4.9 N*m  { 50 kgf*cm, 43 in.*lbf }

  4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL


    1. A01NMLC

      Engage the 7 clips to install the lower instrument panel finish panel as shown in the illustration.

  5. INSTALL INSTRUMENT PANEL FINISH PANEL


    1. A01NILC

      Engage the 2 guides, claw and 2 clips to install the instrument panel finish panel as shown in the illustration.

  6. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    1. Connect each connector.

    2. Engage the 8 clips and 2 guides.

    3. Install the lower instrument panel finish panel sub-assembly with the 2 screws <D>.

    4. A01NMBT

      Engage the 2 claws to close the cover as shown in the illustration.

  7. INSTALL NO. 1 SWITCH HOLE BASE


    1. Connect each connector.

    2. A01NLSK

      Engage the 4 claws and 2 guides to install the No. 1 switch hole base.

  8. INSTALL INSTRUMENT PANEL GARNISH LH


    1. A01NI52

      Engage the 6 clips to install the instrument panel garnish LH.

  9. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. Engage the clamp.

    2. Connect each connector.

    3. A01NINT

      Engage the 3 claws and 3 clips.

    4. w/o Seat Heater System:


      1. Connect the connector to the console box hole cover.

    5. w/ Seat Heater System:


      1. Connect the connector.

      2. Engage the 6 claws to install the seat heater switch with console box hole cover.

    6. A01NJIY

      Engage the 4 claws and 4 clips to install the upper console panel sub-assembly.

  10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A01NIFY

      Turn the shift lever knob sub-assembly clockwise to install the shift lever knob sub-assembly.

  11. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (w/ Navigation System)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  12. INSTALL REAR DECK FLOOR BOX (w/ Navigation System)


    1. A01NIBL

      Install the rear deck floor box with the 3 clips.

  13. INSPECT SUSPENSION CONTROL SYSTEM (w/ Navigation System)

    w/ Air Suspension: Click here