Click here

FRONT SPEED SENSOR REMOVAL

Click here
Click here Click here
Tip:

  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace it together with the front drive shaft assembly.

Click here
  1. Click here

    PRECAUTION (w/ Navigation System for HDD)

    Note:

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) auxiliary battery terminal.

    Table 1. Waiting Time before Disconnecting Cable from Negative (-) Auxiliary Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.
  2. Click here

    PRECAUTION (w/ Air Suspension)

    Note:

    Be sure to read Precaution thoroughly before servicing (Click here).

  3. Click here

    REMOVE REAR DECK FLOOR BOX


    1. A01NIBL

      Remove the 3 clips and the rear deck floor box.

  4. Click here

    DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  5. Click here

    REMOVE FRONT WHEEL

  6. Click here

    REMOVE FRONT SPEED SENSOR


    1. A01NI44

      Using a screwdriver, turn the pins 90 degrees and remove the 2 pin hold clips.

      Tip:

      Use the same procedure for the RH side and LH side.

    2. A01NKEG

      Remove the 5 clips and 3 screws, and turn back the front fender liner.

    3. A01NM0Q

      Disconnect the front speed sensor connector and remove the 2 clamps.

    4. A01NI57E03

      Remove the bolt and No. 2 sensor clamp from the body.

      Table 2. Text in Illustration
      *1 No. 2 Sensor Clamp
    5. A01NKP5E01

      Remove the bolt, No. 1 sensor clamp and front brake flexible hose together from the shock absorber assembly.

      Table 3. Text in Illustration
      *1 No. 1 Sensor Clamp
      *2 Front Brake Flexible Hose
    6. A01NJ7SE02

      Remove the bolt, resin clamp and front speed sensor.

      Table 4. Text in Illustration
      *1 Resin Clamp
      Note:

      • Prevent foreign matter from attaching to the front speed sensor tip.

      • Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.