REAR STABILIZER BAR INSTALLATION

INSTALL REAR STABILIZER BUSHING

1. 

   Install the 2 rear stabilizer bushings to the outside of the stoppers on the rear stabilizer bar.

   Table 1. Text in Illustration

   *1

   Stopper

INSTALL REAR NO. 1 STABILIZER BAR BRACKET

1. Type A:

   
   
   1. 

      Install the rear No. 1 stabilizer bar bracket to the rear stabilizer bushings.

      Table 2. Text in Illustration

      *a	Identification Mark

      Note:

      Ensure that the identification mark is on the right side of the vehicle.

2. Type B:

   
   
   1. 

      Install the 2 rear No. 1 stabilizer bar brackets to the rear stabilizer bushings.

      Table 3. Text in Illustration

      *1	Identification Shape
      *a	Identification Mark

      Note:
      

      • Ensure that the identification shape faces upward.

      • Ensure that the identification mark is on the right side of the vehicle.

INSTALL REAR STABILIZER BAR

1. Type A:

   
   
   1. 

      Install the rear stabilizer bar with 2 rear stabilizer bushings and rear No. 1 stabilizer bar bracket with the 4 nuts.

      Table 4. Text in Illustration

      *a	Identification Mark

      75 N*m

      765 kgf*cm

      55 ft.*lbf

      Note:

      Ensure that the identification mark is on the right side of the vehicle.

2. Type B:

   
   
   1. 

      Install the rear stabilizer bar with 2 rear stabilizer bushings and 2 rear No. 1 stabilizer bar brackets with the 4 nuts.

      Table 5. Text in Illustration

      *a	Identification Mark

      75 N*m

      765 kgf*cm

      55 ft.*lbf

      Note:

      Ensure that the identification mark is on the right side of the vehicle.

INSTALL REAR STABILIZER LINK SUB-ASSEMBLY

1. Install the rear stabilizer link sub-assembly (LH Side).

   
   
   1. 

      Hold the rear lower stabilizer bracket between aluminium plates in a vise as shown in the illustration.

      Note:

      Do not overtighten the vise.

   2. Install the rear stabilizer link sub-assembly to the rear lower stabilizer bracket as shown in the illustration.

      92 N*m

      938 kgf*cm

      68 ft.*lbf

      Tip:

      If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.

   3. 

      Install the rear stabilizer link sub-assembly to the rear stabilizer bar with the nut (B).

      90 N*m

      918 kgf*cm

      66 ft.*lbf

      Tip:

      If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.

   4. Install the rear stabilizer link sub-assembly with rear lower stabilizer bracket to the rear No. 2 suspension arm assembly LH with the 2 nuts (A).

      82 N*m

      836 kgf*cm

      60 ft.*lbf

2. Install the rear stabilizer link sub-assembly (RH Side).

   Tip:

   Perform the same procedure as the LH side.