REAR UPPER ARM INSTALLATION


  1. INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH


    1. A01NJ6U

      Temporarily install the rear upper control arm assembly LH to the rear suspension member sub-assembly with the bolt and nut.

      Note


      • Insert the bolt with the threaded end facing the rear of the vehicle.

      • Since the stopper nut is used, tighten the bolt.

    2. A01NNDPE01

      Set the rear upper control arm assembly LH in the tightening position as shown in the illustration.

      Standard length (A)
      24.3 mm (0.957 in.)
    3. A01NJ6U

      Fully tighten the bolt in the tightening position.

      Torque:
      120 N*m  { 1224 kgf*cm, 89 ft.*lbf }

      Note

      Since the stopper nut is used, tighten the bolt.

  2. INSTALL REAR UPPER CONTROL ARM ASSEMBLY RH

    Tech Tips

    Perform the same procedure as the LH side.

  3. INSTALL REAR SPEED SENSOR WIRE LH (for 2WD)


    1. A01NMGS

      Install the rear speed sensor wire LH to the rear upper control arm assembly LH with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      Note

      Do not twist the rear speed sensor wire LH when installing it.

  4. INSTALL REAR SPEED SENSOR LH (for AWD)

    Tech Tips

    Perform the same procedure as the rear speed sensor wire LH.

  5. INSTALL REAR SPEED SENSOR WIRE RH (for 2WD)


    1. A01NL7T

      Install the rear speed sensor wire RH to the rear upper control arm assembly RH with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      Note

      Do not twist the rear speed sensor wire RH when installing it.

  6. INSTALL REAR SPEED SENSOR RH (for AWD)

    Tech Tips

    Perform the same procedure as the rear speed sensor wire RH.

  7. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH (w/ HID, LED Headlight System)


    1. A01NKSP

      Install the rear height control sensor sub-assembly RH to the rear upper control arm assembly RH with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  8. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Air Suspension)


    1. A01NL7R

      Install the rear height control sensor sub-assembly LH to the rear upper control arm assembly LH with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  9. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

    Click here