HEIGHT CONTROL SWITCH (for Driver Seat) INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for the LHD vehicle.


  1. INSTALL HEIGHT CONTROL SWITCH (for LHD)


    1. A01NJGC

      Engage the 2 claws to install the height control switch to the No. 1 switch hole base.

  2. INSTALL HEIGHT CONTROL SWITCH (for RHD)


    1. A01NN58

      Engage the 2 claws to install the height control switch to the No. 1 switch hole base.

  3. INSTALL NO. 1 SWITCH HOLE BASE


    1. Connect each connector.

    2. A01NLSK

      Engage the 4 claws and 2 guides to install the No. 1 switch hole base.

  4. INSTALL INSTRUMENT PANEL GARNISH LH


    1. A01NI52

      Engage the 6 clips to install the instrument panel garnish LH.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. INSTALL REAR DECK FLOOR BOX


    1. A01NIBL

      Install the rear deck floor box with the 3 clips.

  7. PERFORM INITIALIZATION


    1. Perform initialization Click here.

  8. INSPECT SUSPENSION CONTROL SYSTEM


    1. Inspect the suspension control system Click here.