Click here

HEIGHT CONTROL SENSOR (for Rear Side) INSTALLATION

Click here
Click here Click here
Tip:

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

Click here
  1. Click here

    INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY


    1. A01NMJ1

      Install the rear height control sensor sub-assembly with the 2 nuts.

      5.0 N*m 51 kgf*cm 44 in.*lbf
      Note:

      Do not drop the height control sensor. If the sensor is dropped, replace it with a new one.

    2. A01NJUU

      Install the height control sensor link to the rear upper control arm with the bolt.

      5.4 N*m 55 kgf*cm 48 in.*lbf
    3. A01NK5M

      Install the height control sensor wire harness bracket to the rear suspension member with the bolt.

      5.0 N*m 51 kgf*cm 44 in.*lbf
    4. A01NMN2

      Connect the connector.

  2. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    INSTALL REAR DECK FLOOR BOX


    1. A01NIBL

      Install the rear deck floor box with the 3 clips.

  4. Click here

    CHECK VEHICLE HEIGHT

    Note:

    If the height control sensor link is removed, check the vehicle height.


    1. Change the height control switch from the "NORMAL" position to the "HIGH" position and back to the "NORMAL" position.

    2. Measure the vehicle height (Click here).

  5. Click here

    ADJUST VEHICLE HEIGHT

    Note:

    If the height control sensor has been replaced, be sure to adjust the vehicle height.


    1. Adjust the vehicle height (Click here).

  6. Click here

    PERFORM INITIALIZATION


    1. Perform initialization (Click here).

  7. Click here

    ADJUST HEADLIGHT ASSEMBLY (except LED Headlight)


    1. Adjust the headlight (Click here).

  8. Click here

    ADJUST HEADLIGHT ASSEMBLY (for LED Headlight)


    1. Adjust the headlight (Click here).