OIL PUMP INSTALLATION


  1. INSTALL OIL WITH MOTOR PUMP ASSEMBLY


    1. A01NI5W

      Install the oil with motor pump assembly with the 2 nuts.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

    2. Connect the 2 oil cooler hoses.

    3. Connect the oil pump connector.

  2. INSTALL FRONT BUMPER ASSEMBLY (for Standard)

    Click here

  3. INSTALL FRONT BUMPER ASSEMBLY (for Sport Package)

    Click here

  4. ADD HYBRID TRANSAXLE FLUID


    1. A01NK6SE01
      Text in Illustration
      *1 Filler Nozzle

      Add transaxle fluid until the transaxle fluid level is between 0 mm (0 in.) from the bottom lip of the filler plug opening.

      Note


      • Keep the oil temperature at 5°C (41°F) or higher.

      • Stop the vehicle on a flat road.

      • Recheck the transaxle fluid level after driving following transaxle fluid replacement.

      • Insufficient or excessive amounts of transaxle fluid may be the cause of some trouble.

      • Be sure to add fluid slowly. If fluid is added quickly, the fluid may hit internal parts and bounce back, resulting in fluid coming out of the filler plug opening.

      • Be sure to fully insert the filler nozzle into the filler plug opening.

    2. Using a hexagon socket wrench 10 mm, temporarily tighten the filler plug and gasket.

  5. INSPECT AND ADJUST HYBRID TRANSAXLE FLUID


    1. Set the vehicle to FWD inspection mode Click here.

    2. After waiting for 1 minute or more, stop the engine.

    3. A01NKNZE01
      Text in Illustration
      *1 Filler Plug

      Using a hexagon socket wrench 10 mm, remove the filler plug and gasket.

    4. Add transaxle fluid until the transaxle fluid level is between 0 and 5 mm (0 and 0.197 in.) from the bottom lip of the filler plug opening.

      Note


      • Keep the transaxle fluid temperature at 5°C (41°F) or higher.

      • Stop the vehicle on a flat road.

      • Recheck the transaxle fluid level after driving following transaxle fluid replacement.

      • Insufficient or excessive amounts of transaxle fluid may be the cause of some trouble.

      • Be sure to add fluid slowly. If fluid is added quickly, the fluid may hit internal parts and bounce back, resulting in fluid coming out of the filler plug opening.

      • Be sure to directly check that the transaxle fluid level is within the specified range.

    5. After adding fluid, leave it for 30 seconds so that the fluid surface can become still again, and then check that the fluid level is between 0 to 5 mm (0 to 0.197 in.) from the bottom lip of the filler plug opening. (If the fluid is insufficient, return to the Add Hybrid Transaxle Fluid procedure.)

    6. Check for leaks if the quantity of transaxle fluid is low.

    7. Using a hexagon socket wrench 10 mm, install the filler plug and a new gasket.

      Torque:
      39 N*m  { 398 kgf*cm, 29 ft.*lbf }