CYLINDER HEAD GASKET REMOVAL


  1. REMOVE CAMSHAFT

    Tech Tips

    Click here.

  2. REMOVE NO. 1 CHAIN VIBRATION DAMPER


    1. A01NI89

      Remove the 2 bolts and No. 1 chain vibration damper.

  3. REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY


    1. A01NJZOE01
      Text in Illustration
      *A Type A
      *B Type B
      *1 No. 1 Valve Rocker Arm Sub-assembly
      *2 Valve Lash Adjuster Assembly
      *3 Valve Stem
      *4 Valve Stem Cap

      Remove the 24 No. 1 valve rocker arms sub-assemblies.

      Tech Tips

      Arrange the removed parts in the correct order.

  4. REMOVE VALVE LASH ADJUSTER ASSEMBLY


    1. Remove the 24 valve lash adjuster assemblies from the cylinder head.

      Tech Tips

      Arrange the removed parts in the correct order.

  5. REMOVE VALVE STEM CAP


    1. Remove the 24 valve stem caps.

      Tech Tips

      Arrange the removed parts in the correct order.

  6. REMOVE OUTLET WATER


    1. A01NJ0EE02
      Text in Illustration
      *A w/ EGR System
      *B w/o EGR System
      *a Nut
      *b Bolt

      Remove the 2 bolts, 4 nuts and outlet water.

    2. A01NL0H

      Remove the 2 gaskets and O-ring.

  7. REMOVE CYLINDER HEAD SUB-ASSEMBLY


    1. A01NM8DE01

      Using a 10 mm bi-hexagon wrench, uniformly loosen the 8 cylinder head bolts in the sequence shown in the illustration. Remove the 8 cylinder head bolts and plate washers.

      Note


      • Be careful not to drop washers into the cylinder head sub-assembly.

      • Cylinder head warpage or cracking could result from removing bolts in an incorrect order.

      Tech Tips

      Arrange the removed parts in the correct order.

    2. Remove the cylinder head sub-assembly.

  8. REMOVE CYLINDER HEAD GASKET


    1. Remove the cylinder head gasket.

  9. REMOVE CYLINDER HEAD LH


    1. A01NLUOE01

      Uniformly loosen and remove the 2 cylinder head set bolts in several steps and in the sequence shown in the illustration.

    2. A01NINWE01

      Using a 10 mm bi-hexagon wrench, uniformly loosen the 8 bolts in the sequence shown in the illustration. Remove the 8 cylinder head bolts and plate washers.

      Note


      • Be careful not to drop washers into the cylinder head sub-assembly.

      • Cylinder head warpage or cracking could result from removing bolts in an incorrect order.

      Tech Tips

      Be sure to keep separate the removed parts for each installation position.

    3. Remove the cylinder head LH.

  10. REMOVE NO. 2 CYLINDER HEAD GASKET


    1. Remove the No. 2 cylinder head gasket.

  11. INSPECT CYLINDER HEAD SET BOLT


    1. A01NLL4E04

      Using a vernier caliper, measure the diameter of the threads at the measurement point shown in the illustration.

      Standard diameter
      10.85 to 11.00 mm (0.4272 to 0.4330 in.)
      Minimum diameter
      10.70 mm (0.4212 in.)

      Tech Tips


      • If the diameter is less than the minimum, replace the cylinder head bolt. Failure to do so may lead to engine damage.


      • If there is any thread deformation, replace the cylinder head bolt with a new one.