Click here

BATTERY BLOWER REMOVAL

Click here
Click here Click here
  1. Click here

    PRECAUTION

    Tip:

    Click here.

  2. Click here

    READ OUTPUT DTC


    1. Check for DTCs (Click here).

      Note:

      Check for DTCs and confirm that P0AA6 (High voltage insulation is unusual) is not output before doing removal or installation inside the battery. If the DTC is output, perform troubleshooting first.

  3. Click here

    DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  4. Click here

    REMOVE BATTERY SERVICE HOLE COVER


    1. A01NLK4

      Disengage the 2 clips and 2 guides, and remove the battery service hole cover.

      Tip:

      Because these are 2-piece clips, one side will remain in the bracket when they are being removed.

  5. Click here

    REMOVE SERVICE PLUG GRIP

    CAUTION:

    • Remove the service plug grip to interrupt a high voltage circuit at the time of the check.

    • Keep the removed service plug grip in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.

    • All the high voltage wiring connectors are orange colored.


    1. A01NJ0X

      Wear insulated gloves. Remove the service plug grip after sliding the lever of the service plug grip.

      CAUTION:

      • Keep the removed service plug grip in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.

      • After disconnecting the service plug grip, wait for at least 10 minutes before touching any of the high-voltage connectors or terminals.

      Tip:

      Waiting for at least 10 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.

  6. Click here

    REMOVE BATTERY COVER SUB-ASSEMBLY

    Tip:

    Click here.

  7. Click here

    REMOVE BATTERY COOLING BLOWER ASSEMBLY

    CAUTION:

    Be sure to wear insulated gloves and protective goggles.

    Note:

    • Be sure not to touch the fan part of the battery cooling blower assemblies.

    • Do not lift the battery cooling blower assemblies using the wire harness.


    1. A01NN1K

      Disconnect each battery cooling blower assembly connector and clamp.

    2. A01NKD8

      Remove the 9 nuts and 3 battery cooling blower assemblies.