COMBINATION SWITCH INSPECTION


  1. INSPECT EV DRIVE MODE SWITCH (PATTERN SELECT SWITCH ASSEMBLY)


    1. A01NNF5E01
      Text in Illustration
      *a

      Component without harness connected

      (EV Drive Mode Switch (pattern select switch assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      8 (S) - 9 (E) EV drive mode switch (pattern select switch assembly) being pushed and held Below 1 Ω
      EV drive mode switch (pattern select switch assembly) not pushed 10 kΩ or higher

      If the result is not as specified, replace the EV drive mode switch (pattern select switch assembly).

    2. A01NNF5E02
      Text in Illustration
      *a

      Component without harness connected

      (EV Drive Mode Switch (pattern select switch assembly))

      Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the EV drive mode switch.

      OK
      Measurement Condition Specified Condition
      Auxiliary battery positive (+) → 7 (ILL+) Auxiliary battery negative (-) →10 (ILL-) Illuminates

      If the result is not as specified, replace the EV drive mode switch (pattern select switch assembly).