Click here

HV RELAY ASSEMBLY INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL HYBRID BATTERY JUNCTION BLOCK ASSEMBLY

    CAUTION:

    Be sure to wear insulated gloves and protective goggles.


    1. A01NMQC

      Install the 2 bolts and EV battery fuse.

      3.5 N*m 36 kgf*cm 31 in.*lbf
      Note:

      Be sure to use a torque wrench to tighten the nuts.

    2. A01NN44

      Install the hybrid battery junction block assembly with the 3 nuts.

      7.5 N*m 76 kgf*cm 66 in.*lbf
    3. A01NI2J

      Connect the 2 connectors to the hybrid battery junction block assembly.

      Note:

      Make sure that the connectors are fully engaged.

    4. A01NM1W

      Connect the connector and 2 main battery cable connectors to the hybrid battery junction block assembly.

    5. A01NJTLE01

      Install the No. 3 wire frame to the hybrid battery junction block assembly with the 2 nuts.

      Table 1. Text in Illustration
      *1 Red Tape
      9.0 N*m 92 kgf*cm 80 in.*lbf
      Note:

      • Make sure that the ends of the No. 3 wire frame do not cross over each other.

      • Be sure to connect the No. 3 wire frame to each correct terminal as shown in the illustration.

  2. Click here

    CHECK HIGH VOLTAGE CABLE CONNECTION

    CAUTION:

    Wear insulated gloves and protective goggles.


    1. A01NKVIE01

      Check that each wire harness is being installed securely.

      Table 2. Text in Illustration
      *1 Red Tape *2 No. 3 Wire Frame
      *3 Plastic Cover - -
      Note:

      • Make sure that the end of the No. 3 wire frame do not cross each other.

      • Be sure to connect the No. 3 wire frame to each correct terminal as shown in the illustration.

      • The connectors should be connected securely.

      • The nuts should be fastened securely.

      • Make sure that the 4 plastic covers are engaged securely.

  3. Click here

    INSTALL BATTERY COVER SUB-ASSEMBLY

    Tip:

    Click here.

  4. Click here

    INSTALL SERVICE PLUG GRIP

    CAUTION:

    Wear insulated gloves.

    Note:

    Before connecting the service plug, check that no parts and tools remain and that the high voltage terminals and connectors are connected securely.


    1. A01NLQ6

      Wear insulated gloves and insert the service plug grip in the order shown in the illustration.

    2. Tilt the service plug grip 90° and slide it down until a click sound is heard.

  5. Click here

    INSTALL BATTERY SERVICE HOLE COVER


    1. A01NLK4

      Engage the 2 clips, 2 guides and install the battery service hole cover.

      Note:

      Make sure that the battery service hole cover is installed securely.

  6. Click here

    CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

  7. Click here

    PERFORM INITIALIZATION

    Some systems need initialization after reconnecting the cable to the negative auxiliary battery terminal (Click here).