ECM INSTALLATION


  1. INSTALL ECM


    1. Set the ECM in the engine room ECM box.

    2. A01NJ0S

      Install the engine room ECM cover with the 3 claws.

    3. A01NI66

      Install the No. 1 ECM bracket and No. 2 ECM bracket with the 4 bolts.

      Torque:
      4.5 N*m  { 46 kgf*cm, 40 in.*lbf }
    4. A01NIP8

      Install the wire harness clamp bracket with the 2 bolts.

      Torque:
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }
    5. A01NK12

      Install the ECM with bracket with the 3 bolts.

      Torque:
      19 N*m  { 193 kgf*cm, 14 ft.*lbf }
    6. A01NNDL

      Install the cooler pipe with the bolt.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }
    7. A01NIV7

      Connect the 2 ECM connectors and lower the 2 levers.

      Note


      • When connecting the connectors, make sure that dirt, water or other foreign matter does not become stuck between the connectors and other parts.

      • Make sure that the 2 levers are securely locked.

    8. A01NJ2J

      Install the 2 wire harness clamps.

  2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. INSTALL REAR DECK FLOOR BOX


    1. A01NIBL

      Install the rear deck floor box with the 3 clips.

  4. INSTALL COOL AIR INTAKE DUCT SEAL


    1. A01NJTT

      Install the cool air intake duct seal with the 6 clips.

  5. INSTALL ENGINE ROOM SIDE COVER


    1. A01NNBL

      Install the engine room side cover with the 4 clips.

  6. INSTALL ENGINE ROOM SIDE COVER LH


    1. A01NKHH

      Install the engine room side cover with the 4 clips.

  7. PERFORM INITIALIZATION

    Tech Tips

    Initialization cannot be completed by only disconnecting and reconnecting the cable of the negative (-) battery terminal.


    1. Perform Initialization when replacing the ECM Click here.