SIDE MONITOR SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

VEHICLE BROUGHT TO WORKSHOP

NEXT

INSPECT AUXILIARY BATTERY VOLTAGE

1. Measure the auxiliary battery voltage with the power switch off.

   Standard voltage
   11 to 14 V

   If the voltage is below 11 V, replace or recharge the auxiliary battery before proceeding to the next step.

   
   

   NEXT

CHECK NAVIGATION SYSTEM

1. Refer to the navigation system Click here.

   Result

   Result	Proceed to
   Navigation system is normal	A
   Navigation system is abnormal	B

   
   

   B

   GO TO NAVIGATION SYSTEM Click here

   A

CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

1. Use the intelligent tester to check if the CAN communication system is functioning normally Click here.

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

   
   

   B

   GO TO CAN COMMUNICATION SYSTEM Click here

   A

CHECK FOR DTC*

1. Check for DTCs and note any codes that are output Click here.

2. Clear the DTC Click here.

3. Check for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

   Note

   The parking assist ECU may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the side monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.

   System	Proceed to
   Parking Assist Monitor System (w/ Side Monitor System)	Click here

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

   
   

   B

   Go to step 8

   A

PROBLEM SYMPTOMS TABLE

1. Refer to the Problem Symptoms Table Click here.

   Result

   Result	Proceed to
   Fault is not listed in Problem Symptoms Table	A
   Fault is listed in Problem Symptoms Table	B

   
   

   B

   Go to step 8

   A

OVERALL ANALYSIS AND TROUBLESHOOTING

1. Terminals of ECU Click here.

2. Data List / Active Test Click here.

3. Diagnosis System Click here.

   
   

   NEXT

ADJUST, REPAIR OR REPLACE

NEXT

CONFIRMATION TEST

NEXT