PARKING ASSIST MONITOR SYSTEM (w/ Side Monitor System), Diagnostic DTC:C1613

DTC Code DTC Name
C1613 ACC Voltage is Low or High

DESCRIPTION

This DTC is stored if the parking assist ECU judges as a result of its self check that the voltage received by terminal ACC is not normal.

DTC No. DTC Detection Condition Trouble Area
C1613

  • ACC voltage is low

  • ACC voltage is high

  • Harness or connector

  • Parking assist ECU

WIRING DIAGRAM

A01NIYWE79

INSPECTION PROCEDURE

Note


  • When "System initializing" is displayed on the multi-display assembly after the auxiliary battery terminal disconnected, correct the steering angle neutral point Click here.

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Click here.

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK FOR DTC


    1. Clear the DTCs Click here.

    2. Check for DTCs Click here.

      OK
      DTC C1613 is not output.

      Tech Tips

      If the parking assist ECU cannot read the stored information when it is activated, allowing the ECU to store the information again may return the system to normal.


    NG

    CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU ACC VOLTAGE AND BODY GROUND) Click here

    OK

    USE SIMULATION METHOD TO CHECK Click here

  2. CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU ACC VOLTAGE AND BODY GROUND)


    1. Disconnect the F110 parking assist ECU connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      F110-9 (ACC) - F110-4 (GND1) Power switch on (ACC) 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE PARKING ASSIST ECU Click here