Click here

NAVIGATION SYSTEM Pointer not Displayed on Screen or Pointer does not Move

Click here
Click here Click here
DTC Code DTC Name
  Pointer not Displayed on Screen or Pointer does not Move
Click here

INSPECTION PROCEDURE

Note:
  • w/ G-BOOK System:

  • When replacing the multi-media module receiver assembly or telematics transceiver, perform vehicle contract setting (w/ Telematics Transceiver) (Click here).

  • When replacing the multi-media module receiver assembly, perform vehicle contract setting (w/o Telematics Transceiver) (Click here).

Click here

PROCEDURE


  1. Click here

    CHECK REMOTE TOUCH SWITCH (OPERATION CHECK)


    1. A01NIPFE01

      Enter the "Remote Touch Switch Check" screen. Refer to Check Remote Touch Switch in Operation Check (Click here).

    2. Move the remote touch switch knob and press the switch knob at any blank space on the screen to display the "+" mark.

      Tip:

      • The "+" mark will be displayed at the point where the switch knob was pressed.

      • Even if the pointer is moved, the "+" mark will remain at the position where the pointer was when the switch knob was pressed.

    3. Move the pointer to any position using the remote touch switch knob. When the location of the pointer is changed with the switch knob moved, check that the coordinate values "X" and "Y" change between 0 and 255.

      Result
      Result Proceed to
      Remote touch switch check cannot be performed due to a remote touch switch knob malfunction. A
      The coordinate values "X" and "Y" do not change between 0 and 255 according to the location of the pointer. A
      The coordinate values "X" and "Y" change between 0 and 255 according to the location of the pointer. B
      Table 1. Text in Illustration
      *a Pointer
      *b Coordinates
      *c "+" mark

  2. Click here

    REMOTE TOUCH SELF CHECK (REMOTE TOUCH SWITCH KNOB POSITION RECOGNITION)


    1. Activate self check mode (Click here).

    2. A01NL56E01

      Check remote touch switch knob position recognition.


      1. Move the remote touch switch knob from the lower left to the upper right to check that the brightness of the switch illumination changes.

        Result
        Result Proceed to
        Brightness of the switch illumination changes according to remote touch switch knob operation. A
        Brightness of the switch illumination does not change according to remote touch switch knob operation. B
        Switch illumination remains on. B
        Tip:

        • If the brightness changes according to remote touch switch knob operation, the knob position is being recognized normally.

        • When the switch illumination blinks, the remote touch has stored a DTC.

        Table 2. Text in Illustration
        *a Switch Illumination
        *b Switch Knob

  3. Click here

    USE SIMULATION METHOD TO CHECKClick here

  4. Click here

    REPLACE REMOTE OPERATION BOARD


    1. Replace the remote operation board (Click here).

    2. Check that the pointer is displayed and moves normally.

      OK
      The pointer is displayed and moves normally.

  5. Click here

    END

  6. Click here

    REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLYClick here

  7. Click here

    REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLYClick here