NAVIGATION SYSTEM Switch Operation of Remote Touch not Accepted

INSPECTION PROCEDURE

Note


    w/ G-BOOK System:

  • When replacing the multi-media module receiver assembly or telematics transceiver, perform vehicle contract setting (w/ Telematics Transceiver) Click here.

  • When replacing the multi-media module receiver assembly, perform vehicle contract setting (w/o Telematics Transceiver) Click here.

PROCEDURE


  1. START DIAGNOSTIC MODE


    1. Activate diagnostic mode and check if the "Service Menu" screen can be displayed Click here.

      OK
      Diagnostic mode can be activated.

    NG

    REMOTE TOUCH SELF CHECK (SWITCH OPERATION CHECK) Click here

    OK

  2. CHECK PANEL SWITCH (OPERATION CHECK)


    1. A01NMWV

      Enter the "Panel & Steering Switch Check Mode" screen. Refer to Check Panel & Steering Switch in Operation Check Click here.

    2. Operate the abnormal switch and check if the switch status is correctly displayed.

      OK
      The switch status is correctly displayed as operated.

    NG

    REMOTE TOUCH SELF CHECK (SWITCH OPERATION CHECK) Click here

    OK

    REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY Click here

  3. REMOTE TOUCH SELF CHECK (SWITCH OPERATION CHECK)


    1. Activate self check mode Click here.

    2. A01NL56E01
      Text in Illustration
      *a Switch Illumination
      *b Switch Knob

      Check switch operation.


      1. Move the remote touch switch knob to the lower left.

      2. Check that the "MAP/VOICE" and "MENU" switches illuminate when each switch on the remote touch is pressed.

        Result
        Result Proceed to
        Self check mode cannot be activated. A
        Some switches do not turn on the "MAP/VOICE" and "MENU" switch illumination when they are pressed. A
        All switches turn on the "MAP/VOICE" and "MENU" switch illumination when they are pressed. B

    B

    REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY Click here

    A

  4. REPLACE INTEGRATION PANEL SUB-ASSEMBLY


    1. Replace the integration panel sub-assembly Click here.

    2. Check that each switch operation on the remote touch is accepted normally.

      OK
      Each switch operation is accepted normally.

    NG

    REPLACE REMOTE OPERATION BOARD Click here

    OK

    END