REAR DOOR SPEAKER REMOVAL


  1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG


    1. A01NI7H

      Using a moulding remover, disengage the 3 claws and remove the rear door inside handle bezel plug as shown in the illustration.

  2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL


    1. A01NKVD

      Using a moulding remover, disengage the 2 clips and 3 claws.

    2. Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.

  3. REMOVE REAR DOOR ARMREST COVER


    1. A01NLZS

      Remove the rear door armrest cover.

  4. REMOVE COURTESY LIGHT ASSEMBLY


    1. A01NKV5E02
      Text in Illustration
      *A for LH Side
      *B for RH Side
      *1 Protective Tape

      Using a screwdriver wrapped with protective tape, disengage the claw.

    2. Disconnect the connector and remove the courtesy light assembly.

  5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    1. A01NMVRE01

      Remove the 3 screws.

    2. Using a clip remover, disengage the 7 clips and 2 rear door trim board retainers.

      Text in Illustration
      *1 Rear Door Trim Board Retainer
    3. A01NMFU

      Pull out the rear door trim board sub-assembly in the direction indicated by the arrow as shown in the illustration.

    4. Raise the rear door trim board sub-assembly to disengage the 4 claws and remove the rear door trim board sub-assembly together with the rear door inner glass weatherstrip.

    5. for 12 Speakers or 15 Speakers:


      1. Disconnect the connector.

    6. A01NJ9V

      Disconnect the rear door lock remote control cable assembly and rear door inside locking cable assembly as shown in the illustration.

    7. Remove the 2 rear door trim board retainers (green) from the rear door trim board sub-assembly.

  6. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP


    1. A01NKBO

      Using a moulding remover, disengage the 4 claws and remove the rear door inner glass weatherstrip from the rear door trim board sub-assembly as shown in the illustration.

  7. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 12 or 15 Speakers)


    1. A01NK08

      Disengage the clamp.

    2. Disengage the 3 claws and remove the rear No. 2 speaker assembly.

  8. REMOVE REAR NO. 1 SPEAKER ASSEMBLY


    1. A01NNDS

      Disconnect the connector.

    2. Remove the 3 screws and rear No. 1 speaker assembly.