REAR SEAT ENTERTAINMENT SYSTEM Display Signal Circuit between Multi-display Controller and Television Display

DESCRIPTION

This is the display signal circuit from the multi-display controller sub-assembly to the television display assembly.

WIRING DIAGRAM

A01NIY5E04

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)


    1. Disconnect the P70 multi-display controller sub-assembly connector.

    2. Disconnect the a17 television display assembly LH connector.

    3. Disconnect the Z21 television display assembly RH connector.

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      P70-14 (NTS2) - a17-10 (NTSC) Always Below 1 Ω
      P70-15 (SGN2) - a17-22 (SGN2) Always Below 1 Ω
      P70-11 (NTS1) - Z21-10 (VV1+) Always Below 1 Ω
      P70-12 (SGN1) - Z21-22 (VV1-) Always Below 1 Ω
      P70-14 (NTS2) - Body ground Always 10 kΩ or higher
      P70-15 (SGN2) - Body ground Always 10 kΩ or higher
      P70-11 (NTS1) - Body ground Always 10 kΩ or higher
      P70-12 (SGN1) - Body ground Always 10 kΩ or higher
      P70-16 (SLDB) - Body ground Always 10 kΩ or higher
      P70-13 (SLDA) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here