HEIGHT CONTROL SENSOR INSTALLATION


  1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY


    1. A019LM1

      Install the rear height control sensor sub-assembly with the 2 nuts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    2. Engage the guide and install the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }
    3. A019MCE

      Engage the guide and install the bolt.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    4. Connect the connector.

  2. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. CHECK VEHICLE HEIGHT (w/ Air Suspension)

    Note

    If the height control sensor link is removed, check the vehicle height.


    1. Change the height control switch from the "NORM" position to the "HIGH" position and back to the "NORM" position.

    2. Measure the vehicle height Click here.

  5. ADJUST VEHICLE HEIGHT (w/ Air Suspension)

    Note

    If the height control sensor has been replaced, be sure to adjust the vehicle height.


    1. Adjust the vehicle height Click here.

  6. HEIGHT CONTROL SENSOR SIGNAL INITIALIZATION (w/o Air Suspension)

    Click here

  7. ADJUST HEADLIGHT AIMING

    Click here