HEIGHT CONTROL SENSOR REMOVAL


  1. PRECAUTION


    1. w/ Air Suspension:

      Note

      Be sure to read Precaution thoroughly before servicing Click here.

    2. w/ Navigation System for HDD:

      Note

      After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

      Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
      Specification Waiting Time
      w/o Telematics transceiver 60 sec.
      w/ Telematics transceiver 120 sec.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR WHEEL

  4. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY


    1. A019MCE

      Disconnect the connector.

    2. Remove the bolt and disengage the guide.

    3. A019LM1

      Remove the bolt and disengage the guide.

    4. Remove the 2 nuts and rear height control sensor sub-assembly.

      Note

      Do not drop the rear height control sensor sub-assembly. If it is dropped, replace it with a new one.