Click here

LIGHTING SYSTEM Taillight Relay Circuit

Click here
Click here Click here
DTC Code DTC Name
  Taillight Relay Circuit
Click here

DESCRIPTION

The main body ECU (multiplex network body ECU) controls the operation of the TAIL relay.

Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Note:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

Click here

PROCEDURE


  1. Click here

    PERFORM ACTIVE TEST USING INTELLIGENT TESTER


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Main Body / Active Test.

    5. Check that the relay operates.

      Table 1. Main Body
      Tester Display Test Part Control Range Diagnostic Note
      Taillight Relay Taillight relay ON/OFF -
      OK
      Taillight relay operates. (Taillights illuminate.)

  2. Click here

    INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    1. A019NRTE01

      Remove the instrument panel junction block assembly.

    2. Connect a positive (+) lead from the battery to terminal 2K-1.

    3. Connect a negative (-) lead from the battery to terminal A-14.

    4. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      2F-39 - Battery negative Always 11 to 14 V
      2H-5 - Battery negative Always 11 to 14 V
      Table 2. Text in Illustration
      *1

      Component without harness connected

      (Instrument Panel Junction Block Assembly)

  3. Click here

    CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)


    1. A019PJ0E01

      Disconnect the 2K instrument panel junction block assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      2K-1 - Body ground Always 11 to 14 V
      Table 3. Text in Illustration
      *1

      Front view of wire harness connector

      (to Instrument Panel Junction Block Assembly)

  4. Click here

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

  5. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  6. Click here

    REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)Click here

  7. Click here

    REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY