HIGH INTENSITY DISCHARGE HEADLIGHT BULB INSTALLATION


  1. INSTALL DISCHARGE HEADLIGHT BULB


    1. Set the discharge headlight bulb to the headlight unit.

      Note

      Do not touch the bulb glass.

    2. A019M5OE01

      Lock the set spring to install the discharge headlight bulb as shown in the illustration.

  2. INSTALL HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY


    1. A019KD1E01
      Text in Illustration
      *a Red Line

      Turn the socket of the headlight light control ECU sub-assembly in the direction indicated by the arrow shown in the illustration to connect it.

      Note


      • Check that the O-ring is installed on the headlight light control ECU sub-assembly.

      • Check that the O-ring is not damaged or contaminated with foreign matter. If there is any damage, replace the O-ring with a new one.

      • Do not pull the headlight light control ECU sub-assembly with the socket connected.

    2. Check that the red line on the output harness is not twisted and store the harness in the headlight assembly securely so that the output harness is not pinched.

    3. A019M1UE01
      Text in Illustration
      *a Lock Mark

      Turn the headlight light control ECU sub-assembly in the direction indicated by the arrow shown in the illustration until the lock marks are aligned to install it.

      Note


      • To prevent incomplete installation, make sure to fully push in and turn the headlight light control ECU sub-assembly until the lock marks are aligned.

      • Do not apply excessive force using a tool.

    4. Connect the connector.

  3. INSTALL COOL AIR INTAKE DUCT SEAL (for LH Side)


    1. Install the cool air intake duct seal with the 6 clips.

  4. INSTALL ENGINE ROOM SIDE COVER


    1. Engage the guide.

    2. Install the engine room side cover with the 4 clips.

  5. INSTALL ENGINE ROOM SIDE COVER LH (for LH Side)


    1. Engage the guide.

    2. Install the engine room side cover LH with the 4 clips.

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.