HIGH INTENSITY DISCHARGE HEADLIGHT BULB REMOVAL


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE ENGINE ROOM SIDE COVER


    1. A019LQM

      Remove the 4 clips.

    2. Disengage the guide and remove the engine room side cover.

  4. REMOVE ENGINE ROOM SIDE COVER LH (for LH Side)


    1. A019K5V

      Remove the 4 clips.

    2. Disengage the guide and remove the engine room side cover LH.

  5. REMOVE COOL AIR INTAKE DUCT SEAL (for LH Side)


    1. A019MCL

      Remove the 6 clips and cool air intake duct seal.

  6. REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY

    CAUTION:

    The headlight light control ECU sub-assembly may be hot when the light control switch is in the HEAD position or right after it is turned off. Check that the headlight light control ECU sub-assembly is not hot before starting work.


    1. Disconnect the connector.

    2. A019JW9

      Turn the headlight light control ECU sub-assembly in the direction indicated by the arrow shown in the illustration, and disconnect it.

      Note


      • Do not apply excessive force using a tool.

      • Do not damage the O-ring or allow it to become contaminated with foreign matter. If the O-ring is damaged or contaminated, water may get into the headlight assembly, resulting in a malfunction of the headlight light control ECU sub-assembly.

    3. A019PH9

      Turn the socket of the headlight light control ECU sub-assembly in the direction indicated by the arrow shown in the illustration, and remove it.

      Note

      Do not pull the headlight light control ECU sub-assembly with the socket connected.

  7. REMOVE DISCHARGE HEADLIGHT BULB


    1. A019PFYE01

      Release the set spring as shown in the illustration and remove the discharge headlight bulb.

      Note

      Do not touch the bulb glass.