AIRBAG SYSTEM, Diagnostic DTC:B1635/24

Click here

DESCRIPTION

The rear airbag sensor LH circuit consists of the center airbag sensor assembly, side airbag sensor LH, and rear airbag sensor LH.

The side airbag sensor LH and rear airbag sensor LH detect impacts to the vehicle and send signals to the center airbag sensor assembly to determine if the airbag should be deployed.

DTC B1635/24 is recorded when a malfunction is detected in the rear airbag sensor LH.

Click here

INSPECTION PROCEDURE

Click here

PROCEDURE

1. Click here

   CHECK REAR AIRBAG SENSOR LH

   
   
   1. 

      Turn the engine switch off.

   2. Disconnect the cable from the negative (-) battery terminal.

      Note:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   3. Interchange the rear airbag sensor RH with LH and connect the connectors to them.

   4. Connect the cable to the negative (-) battery terminal.

   5. Turn the engine switch on (IG), and wait for at least 60 seconds.

   6. Clear the DTCs stored in the memory (Click here).

   7. Turn the engine switch off.

   8. Turn the engine switch on (IG), and wait for at least 60 seconds.

   9. Check for DTCs (Click here).

      Result
      Result Proceed to DTC B1630/23 and B1635/24 are not output A DTC B1630/23 is output. B DTC B1635/24 is output. C

      Table 1. Text in Illustration

      *1	Rear Airbag Sensor RH
      *2	Side Airbag Sensor LH

      Tip:

      Codes other than DTC B1630/23 and B1635/24 may be output at this time, but they are not related to this check.

   
   
   • AClick here
   • BClick here
   • CClick here
2. Click here

   REPLACE CENTER AIRBAG SENSOR ASSEMBLYClick here

3. Click here

   REPLACE REAR AIRBAG SENSOR LHClick here

4. Click here

   USE SIMULATION METHOD TO CHECKClick here