HEADUP DISPLAY INSTALLATION


  1. INSTALL COMBINATION METER MIRROR ECU


    1. A019LBS

      Install the combination meter mirror ECU with the 4 screws.

      Note


      • Make sure that the ECU is installed securely.

      • Do not drop the screws.

    2. Engage the clamp.

    3. Connect the connector.

    4. A019NEWE01

      Insert the No. 1 heater to register duct in the order indicated in the illustration to temporarily install it.

    5. A019NFX

      Install the No. 1 heater to register duct with the 2 screws.

    6. A019NLY

      Connect the connectors.

  2. INSTALL COMBINATION METER ASSEMBLY


    1. Connect each connector.

    2. A019MSP

      Install the combination meter assembly with the 2 screws.

  3. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL


    1. A019N75

      Engage the 4 clips and 2 guides.

    2. Install the No. 1 instrument cluster finish panel with the 2 clips and 2 screws.

  4. INSTALL NO. 2 INSTRUMENT PANEL HOLE COVER

    Tech Tips

    Use the same procedure as for the No. 1 instrument panel hole cover.

  5. INSTALL NO. 1 INSTRUMENT PANEL HOLE COVER


    1. A019K3Y

      Engage the 2 claws to install the No. 1 instrument panel hole cover.

  6. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    1. Connect each connector.

    2. Engage the 8 clips and 2 guides.

    3. Install the lower instrument panel finish panel sub-assembly with the 2 screws <D>.

    4. A019NKJ

      Engage the 2 claws to close the cover as shown in the illustration.

  7. INSTALL NO. 1 SWITCH HOLE BASE


    1. Connect each connector.

    2. A019N7C

      Engage the 4 claws and 2 guides to install the No. 1 switch hole base.

  8. INSTALL INSTRUMENT PANEL GARNISH LH


    1. A019K28

      Engage the 6 clips to install the instrument panel garnish LH.

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note


    • Reset the auto tilt away function setting to the previous condition by changing the customize parameter Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. INSPECT SUSPENSION CONTROL SYSTEM (w/ Air Suspension)

    Click here