ACCESSORY METER REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL


    1. A019KU9E01
      Text in Illustration
      *1 Protective Tape
      *2 Moulding Remover B
      *3 Moulding Remover D

      Apply protective tape to the areas shown in the illustration.

    2. Insert moulding remover B and D as shown in the illustration.

    3. Pull down moulding remover B in direction (1). With moulding remover B being pulled down, pull down moulding remover D in direction (2) to disengage the clip and guide.

    4. A019KMNE01
      Text in Illustration
      *1 Protective Tape
      *2 Moulding Remover B
      *3 Moulding Remover D

      Apply protective tape to the areas shown in the illustration.

    5. Insert moulding remover B and D as shown in the illustration.

    6. Pull down moulding remover B in direction (1). With moulding remover B being pulled down, pull down moulding remover D in direction (2) to disengage the clip.

    7. A019OTC

      Disengage the 2 clips and remove the center instrument cluster finish panel as shown in the illustration.

  4. REMOVE ACCESSORY METER ASSEMBLY


    1. A019NH5

      Remove the 3 screws.

    2. Disengage the 2 clips.

    3. Disconnect each connector and remove the accessory meter assembly.