Click here

COMBINATION METER INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL COMBINATION METER ASSEMBLY


    1. Connect each connector.

    2. A019MSP

      Install the combination meter assembly with the 2 screws.

  2. Click here

    INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL


    1. A019N75

      Engage the 4 clips and 2 guides.

    2. Install the No. 1 instrument cluster finish panel with the 2 clips and 2 screws.

  3. Click here

    INSTALL NO. 2 INSTRUMENT PANEL HOLE COVER

    Tip:

    Use the same procedure as for the No. 1 instrument panel hole cover.

  4. Click here

    INSTALL NO. 1 INSTRUMENT PANEL HOLE COVER


    1. A019K3Y

      Engage the 2 claws to install the No. 1 instrument panel hole cover.

  5. Click here

    INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    1. Connect each connector.

    2. Engage the 8 clips and 2 guides.

    3. Install the lower instrument panel finish panel sub-assembly with the 2 screws <D>.

    4. A019NKJ

      Engage the 2 claws to close the cover as shown in the illustration.

  6. Click here

    INSTALL NO. 1 SWITCH HOLE BASE


    1. Connect each connector.

    2. A019N7C

      Engage the 4 claws and 2 guides to install the No. 1 switch hole base.

  7. Click here

    INSTALL INSTRUMENT PANEL GARNISH LH


    1. A019K28

      Engage the 6 clips to install the instrument panel garnish LH.

  8. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    • Reset the auto tilt away function setting to the previous condition by changing the customize parameter (Click here).

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  9. Click here

    INSPECT SUSPENSION CONTROL SYSTEM (w/ Air Suspension)

    (Click here)