Click here

AIRBAG SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Click here
Click here Click here
Tip:

*: Use the intelligent tester.


  1. Click here

    VEHICLE BROUGHT TO WORKSHOP


    • NEXT
  2. Click here

    CUSTOMER PROBLEM ANALYSIS


    1. Confirm problem symptoms (Click here).


      • NEXT
  3. Click here

    CHECK CAN COMMUNICATION SYSTEM*


    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Tip:

      • Refer to Bus Check for the CAN communication system (Click here).

      • The center airbag sensor assembly is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.

      Result
      Result Proceed to
      CAN communication DTC is not output. A
      CAN communication DTC is output. B

      • B
      • INSPECT CAN COMMUNICATION CIRCUIT (See pageClick here)
      • A
  4. Click here

    SRS WARNING LIGHT CHECK


    1. Proceed to Diagnosis System (Click here).


      • NEXT
  5. Click here

    CHECK FOR DTC*


    1. Proceed to DTC Check / Clear (Click here).

      Result
      Result Proceed to
      DTC is output. A
      DTC is not output. B

      • B
      • GO TO STEP 7
      • A
  6. Click here

    DIAGNOSTIC TROUBLE CODE CHART


    1. Proceed to Diagnostic Trouble Code Chart (Click here).


      • NEXT
      • GO TO STEP 9
  7. Click here

    SYMPTOM SIMULATION


    1. Proceed to Diagnosis System (Click here).


      • NEXT
  8. Click here

    PROBLEM SYMPTOMS TABLE


    1. Proceed to Problem Symptoms Table (Click here).


      • NEXT
  9. Click here

    CIRCUIT INSPECTION*


    • NEXT
  10. Click here

    IDENTIFICATION OF PROBLEM


    • NEXT
  11. Click here

    REPAIR OR REPLACEMENT


    • NEXT
  12. Click here

    CONFIRMATION TEST


    • NEXT
    • END