SECURITY INDICATOR LIGHT ASSEMBLY INSPECTION


  1. INSPECT SECURITY INDICATOR LIGHT


    1. Apply battery voltage from the wire harness back side between the specified terminals of the indicator, and check the lighting condition of the security indicator.

      A019L77E04
      Standard
      w/ Navigation System
      Measurement Condition Specified Condition

      Battery positive (+) → Terminals G36-37 (SEUC)

      Battery negative (-) → Terminals G36-12 (GND)

      		 Security indicator comes on
      w/ Audio and Visual System (w/ Multi-display)
      Measurement Condition Specified Condition

      Battery positive (+) → Terminals G38-20 (SEUC)

      Battery negative (-) → Terminals G37-20 (GND1)

      		 Security indicator comes on
      w/ Audio and Visual System (w/o Multi-display)
      Measurement Condition Specified Condition

      Battery positive (+) → Terminals G8-7 (LP)

      Battery negative (-) → Terminals G8-9 (GND)

      		 Security indicator comes on
      Text in Illustration
      *1

      Component with harness connected

      (Multi-media Module Receiver Assembly)

      		 *2

      Component with harness connected

      (Radio Receiver Assembly)
      *3

      Component with harness connected

      (Radio Receiver Assembly)

      		 *4 w/ Navigation System
      *5 w/ Audio and Visual System (w/ Multi-display) *6 w/ Audio and Visual System (w/o Multi-display)

      If the result is not as specified, replace the multi-media module receiver assembly*1 or radio receiver assembly*2.


      • *1: w/ Navigation System

      • *2: w/ Audio and Visual System