Click here

ENTRY AND START SYSTEM (for Start Function), Diagnostic DTC:B2277

Click here
Click here Click here
DTC Code DTC Name
B2277 Detecting Vehicle Submersion
Click here

DESCRIPTION

This DTC is stored when the submersion circuit monitor inside the power management control ECU detects a large amount of water.

DTC No. DTC Detection Condition Trouble Area
B2277 The submersion circuit monitor inside the power management control ECU detects a large amount of water. Power management control ECU
Click here

INSPECTION PROCEDURE

Note:

  • When the power management control ECU is replaced with a new one and the cable from the negative (-) battery terminal is connected, the power source mode becomes the on (IG) mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.

Click here

PROCEDURE


  1. Click here

    CHECK FOR DTC


    1. Clear the DTC (Click here).

    2. Turn the engine switch on (IG).

    3. After 330 seconds have elapsed, check if the DTC has been set again.

      Result
      Result Proceed to
      DTC B2277 is not output. A
      DTC B2277 is output (for LHD). B
      DTC B2277 is output (for RHD). C
      Tip:

      If there are any signs that water was present, before replacing the power source control ECU, take measures to prevent any further water entry.


  2. Click here

    REPLACE POWER MANAGEMENT CONTROL ECU (for LHD)Click here

  3. Click here

    REPLACE POWER MANAGEMENT CONTROL ECU (for RHD)Click here

  4. Click here

    USE SIMULATION METHOD TO CHECKClick here