CAN COMMUNICATION SYSTEM Center Airbag Sensor Communication Stop Mode

DESCRIPTION

Detection Item Symptom Trouble Area
Center Airbag Sensor Communication Stop Mode

  • "SRS Airbag" is not displayed on "Communication Bus Check" screen of the intelligent tester.

  • Applies to Center Airbag Sensor Communication Stop Mode in DTC Combination Table.

  • Center airbag sensor assembly branch wire or connector

  • Power source circuit of center airbag sensor assembly

  • Center airbag sensor assembly

WIRING DIAGRAM

A019K83E14
A019MMGE01

INSPECTION PROCEDURE

Note


  • Turn the engine switch off before measuring the resistances between CAN bus main wires and between CAN bus branch wires.

  • Turn the engine switch off before inspecting CAN bus wires for a ground short.

  • After the engine switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.

  • Before measuring the resistance, leave the vehicle as is for at least 1minute and do not operate the engine switch, any other switches or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

Tech Tips


  • Operating the engine switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.

  • Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.

PROCEDURE


  1. CHECK CAN BUS WIRE FOR DISCONNECTION (CENTER AIRBAG SENSOR ASSEMBLY BRANCH WIRE)


    1. Turn the engine switch off.

    2. A019O0VE11
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Center Airbag Sensor)

      Disconnect the center airbag sensor connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      F29-13 (CANH) - F29-22 (CANL) Engine switch off 54 to 69 Ω

    NG

    REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (CENTER AIRBAG SENSOR ASSEMBLY BRANCH WIRE)

    OK

  2. CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)


    1. A019O0VE12
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Center Airbag Sensor)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      F29-21 (IG2) - Body ground Engine switch on (IG) 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)

    OK

  3. CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)


    1. A019O0VE13
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Center Airbag Sensor)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F29-25 (E1) - Body ground Always Below 1 Ω
      F29-26 (E2) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT)

    OK

    REPLACE CENTER AIRBAG SENSOR ASSEMBLY