CAN COMMUNICATION SYSTEM Certification ECU Communication Stop Mode

DESCRIPTION

Detection Item Symptom Trouble Area
Certification ECU Communication Stop Mode

  • "Smart Access/Wireless Tuner" is not displayed on "Communication Bus Check" screen of the intelligent tester.

  • Applies to Certification ECU Communication Stop Mode in DTC Combination Table.

  • Power source circuit of certification ECU

  • Certification ECU main wire or connector

  • Certification ECU

WIRING DIAGRAM

A019NODE02
A019NFHE02

INSPECTION PROCEDURE

Note


  • Turn the engine switch off before measuring the resistances between CAN bus main wires and between CAN bus branch wires.

  • Turn the engine switch off before inspecting CAN bus wires for a ground short.

  • After the engine switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.

  • Before measuring the resistance, leave the vehicle as is for at least 1minute and do not operate the engine switch, any other switches or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

Tech Tips


  • Operating the engine switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.

  • Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.

PROCEDURE


  1. CHECK CAN BUS WIRE FOR DISCONNECTION (CERTIFICATION ECU MAIN WIRE)


    1. Turn the engine switch off.

    2. A019N51E06
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Certification ECU)

      Disconnect the certification ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      F58-9 (CANH) - F58-10 (CANL) Engine switch off 108 to 132 Ω

    NG

    REPAIR OR REPLACE CAN BUS MAIN WIRE OR CONNECTOR (CERTIFICATION ECU MAIN WIRE)

    OK

  2. CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)


    1. A019N51E05
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Certification ECU)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      F58-1 (+B) - Body ground Always 11 to 14 V
      F58-16 (IG) - Body ground Engine switch on (IG) 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)

    OK

  3. CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)


    1. A019N51E04
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Certification ECU)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F58-15 (E) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT)

    OK

    REPLACE SMART KEY ECU ASSEMBLY (CERTIFICATION ECU)