INTEGRATION RELAY REMOVAL


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 1 RELAY BLOCK COVER


    1. A019LFU

      Disengage the 3 claws and remove the upper No. 1 relay block cover.

    2. A019KEV

      Disengage the 4 claws and remove the lower No. 1 relay block cover.

  4. REMOVE ENGINE ROOM JUNCTION BLOCK ASSEMBLY


    1. A019K8C

      Disengage the 2 claws and pull up the engine room junction block assembly as shown in the illustration.

    2. A019O5C

      Disconnect the 3 connectors and remove the engine room junction block assembly.