POWER MANAGEMENT CONTROL ECU (for RHD) REMOVAL


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system Click here.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A019LPB

      Turn the shift lever knob sub-assembly counterclockwise and remove the shift lever knob sub-assembly.

  4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

    Tech Tips

    Use the same procedure for the RHD and LHD Click here.

  5. REMOVE INSTRUMENT PANEL FINISH PANEL


    1. A019PC7

      Pull the instrument panel finish panel in the direction indicated by the arrow to disengage the claw, 2 clips and 2 guides, and remove the instrument panel finish panel.

  6. REMOVE FRONT DOOR SCUFF PLATE LH


    1. A019LA0

      Disengage the 7 claws, 4 clips and guide, and remove the front door scuff plate LH.

      Tech Tips

      A part of the clip remains on the vehicle side.

    2. w/ Illumination:


      1. Disconnect the connector.

  7. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH


    1. A019L27

      Remove the clip.

    2. Disengage the 2 clips and remove the cowl side trim sub-assembly LH.

  8. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Tech Tips

    Use the same procedure for the RHD and LHD Click here.

  9. REMOVE INSTRUMENT PANEL GARNISH LH


    1. A019MAJ

      Using moulding remover B, disengage the 6 clips and remove the instrument panel garnish LH as shown in the illustration.

  10. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

    Tech Tips

    Use the same procedure for the RHD and LHD Click here.

  11. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Tech Tips

    Use the same procedure for the RHD and LHD Click here.

  12. REMOVE ECU INTEGRATION BOX


    1. A019KVF

      Remove the bolt, 2 nuts and ECU integration box.

  13. REMOVE POWER MANAGEMENT CONTROL ECU


    1. A019MRO

      Disengage the 2 claws and remove the power management control ECU as shown in the illustration.