Click here

GENERATOR REMOVAL

Click here
Click here Click here
  1. Click here

    PRECAUTION (w/ Navigation System for HDD)

    Note:

    After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Table 1. Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.
  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE ENGINE ROOM SIDE COVER


    1. A019LQM

      Remove the 4 clips.

    2. Disengage the guide and remove the engine room side cover.

  4. Click here

    REMOVE ENGINE ROOM SIDE COVER LH


    1. A019K5V

      Remove the 4 clips.

    2. Disengage the guide and remove the engine room side cover LH.

  5. Click here

    REMOVE COOL AIR INTAKE DUCT SEAL


    1. A019MCL

      Remove the 6 clips and cool air intake duct seal.

  6. Click here

    REMOVE V-RIBBED BELT


    1. A019L02

      Attach a wrench to the hexagonal portion of the belt tensioner as shown in the illustration, rotate the belt tensioner clockwise, and remove the V-ribbed belt.

  7. Click here

    REMOVE GENERATOR ASSEMBLY


    1. A019JY8

      Disconnect the generator connector.

    2. Remove the terminal cap.

    3. Remove the nut and disconnect the generator wire.

    4. Remove the bolt and wire harness clamp bracket.

    5. Disconnect the wire harness clamp.

    6. A019LIQ

      Remove the 2 bolts and generator.