SIDE MONITOR SYSTEM, Diagnostic DTC:C1683, C1684

DTC Code DTC Name
C1683 Side Camera Feedback Malfunction
C1684 Side Camera Current Malfunction

DESCRIPTION

DTC C1683 is stored if the parking assist ECU judges as a result of its self check that a synchronization problem is occurring in the image signal sent from the side television camera assembly to the parking assist ECU.

DTC C1684 is stored if the parking assist ECU judges as a result of its self check that there is a problem with the current supplied from the side television camera assembly connected to the parking assist ECU.

DTC No. DTC Detection Condition Trouble Area
C1683 Side Camera Feedback Malfunction

  • Harness or connector

  • Parking assist ECU

  • Side television camera assembly

  • Outer rear view mirror assembly (for front passenger)
C1684 Side Camera Current Malfunction

WIRING DIAGRAM


  1. for LHD

    A019NOJE18

  2. for RHD

    A019NOJE21

INSPECTION PROCEDURE

Note


  • When "System initializing" is displayed on the parking assist ECU after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point Click here.

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the side monitor system may be needed Click here.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - OUTER REAR VIEW MIRROR ASSEMBLY AND BODY GROUND)


    1. Disconnect the F103 and F104 parking assist ECU connectors.

    2. Disconnect the I1*1 or J11*2 outer rear view mirror assembly (for front passenger) connector.


      • *1: for LHD

      • *2: for RHD

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      for LHD
      Tester Connection Condition Specified Condition
      F104-34 (SCV-) - I1-2 (SCV-) Always Below 1 Ω
      F104-10 (SCV+) - I1-1 (SCV+) Always Below 1 Ω
      F104-33 (SGND) - I1-5 (SGND) Always Below 1 Ω
      F104-32 (SCB+) - I1-4 (SCB+) Always Below 1 Ω
      F103-4 (GND1) - Body ground Always Below 1 Ω
      F104-34 (SCV-) - Body ground Always 10 kΩ or higher
      F104-10 (SCV+) - Body ground Always 10 kΩ or higher
      F104-33 (SGND) - Body ground Always 10 kΩ or higher
      F104-32 (SCB+) - Body ground Always 10 kΩ or higher
      F104-32 (SCB+) - F104-10 (SCV+) Always 10 kΩ or higher
      F104-32 (SCB+) - F104-34 (SCV-) Always 10 kΩ or higher
      F104-32 (SCB+) - F104-33 (SGND) Always 10 kΩ or higher
      F104-10 (SCV+) - F104-34 (SCV-) Always 10 kΩ or higher
      F104-10 (SCV+) - F104-33 (SGND) Always 10 kΩ or higher
      F104-34 (SCV-) - F104-33 (SGND) Always 10 kΩ or higher
      for RHD
      Tester Connection Condition Specified Condition
      F104-34 (SCV-) - J11-2 (SCV-) Always Below 1 Ω
      F104-10 (SCV+) - J11-1 (SCV+) Always Below 1 Ω
      F104-33 (SGND) - J11-5 (SGND) Always Below 1 Ω
      F104-32 (SCB+) - J11-4 (SCB+) Always Below 1 Ω
      F103-4 (GND1) - Body ground Always Below 1 Ω
      F104-34 (SCV-) - Body ground Always 10 kΩ or higher
      F104-10 (SCV+) - Body ground Always 10 kΩ or higher
      F104-33 (SGND) - Body ground Always 10 kΩ or higher
      F104-32 (SCB+) - Body ground Always 10 kΩ or higher
      F104-32 (SCB+) - F104-10 (SCV+) Always 10 kΩ or higher
      F104-32 (SCB+) - F104-34 (SCV-) Always 10 kΩ or higher
      F104-32 (SCB+) - F104-33 (SGND) Always 10 kΩ or higher
      F104-10 (SCV+) - F104-34 (SCV-) Always 10 kΩ or higher
      F104-10 (SCV+) - F104-33 (SGND) Always 10 kΩ or higher
      F104-34 (SCV-) - F104-33 (SGND) Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. INSPECT PARKING ASSIST ECU (SCB+, SGND)


    1. Reconnect the F103 and F104 parking assist ECU connectors.

    2. A019NA9E21
      Text in Illustration
      *a

      Component with harness connected

      (Parking Assist ECU)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F104-33 (SGND) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      F104-32 (SCB+) - F104-33 (SGND) Engine switch on (IG), side monitor main switch on 5.5 to 7.05 V

    NG

    REPLACE PARKING ASSIST ECU Click here

    OK

  3. INSPECT SIDE TELEVISION CAMERA ASSEMBLY (SCV+, SGND)


    1. Reconnect the I1*1 or J11*2 outer rear view mirror assembly (for front passenger) connector.


      • *1: for LHD

      • *2: for RHD

      A019OG5E20
      Text in Illustration
      *a

      Component with harness connected

      (Parking Assist ECU)

      		 *b Waveform A
      *c Waveform B *d Synchronization Signal
      *e Video Waveform - -

      Tech Tips


      • A waterproof connector is used for the side television camera assembly. Therefore, inspect the waveform at the parking assist ECU with the connector connected.

      • The video waveform changes according to the image sent by the side television camera assembly.

    2. Measure the resistance according to the value(s) in the table below.

      OK
      Waveform is as shown in the illustration.
      Item Content
      Terminal No. (Symbol) F104-10 (SCV+) - F104-33 (SGND)
      Tool Setting 200 mV/DIV., 50 μsec./DIV.
      Condition

      • Waveform A: Engine switch on (IG), side monitor main switch on and camera lens is not covered, displaying an image

      • Waveform B: Engine switch on (IG), side monitor main switch on and camera lens is covered, blacking out the screen

    NG

    REPLACE SIDE TELEVISION CAMERA ASSEMBLY Click here

    OK

    REPLACE PARKING ASSIST ECU Click here

  4. REPLACE SIDE TELEVISION CAMERA ASSEMBLY


    1. Replace the side television camera assembly with a new or known good one Click here.


    NEXT

  5. CHECK FOR DTC


    1. Clear the DTCs Click here.

    2. Check for DTCs Click here.

      OK
      DTC C1683 or C1684 is not output.
      Result
      Result Proceed to
      OK A
      NG (for LHD) B
      NG (for RHD) C

    B

    REPLACE OUTER REAR VIEW MIRROR ASSEMBLY RH Click here

    C

    REPLACE OUTER REAR VIEW MIRROR ASSEMBLY LH Click here

    A

    END (SIDE TELEVISION CAMERA ASSEMBLY WAS DEFECTIVE)