PARKING ASSIST MONITOR SYSTEM (w/o Side Monitor System) DATA LIST / ACTIVE TEST


  1. DATA LIST

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Back Door*1 or Main Body*2 / Data List.


      • *1: w/ Power Back Door System

      • *2: w/o Power Back Door System

    5. Read the Data List according to the display on the intelligent tester.

    Back Door (w/ Power Back Door System)
    Tester Display Measurement Item/Range Normal Condition Diagnostic Note
    Courtesy SW Back door courtesy light switch signal/ON or OFF

    ON: Back door open

    OFF: Back door closed

    		 -
    Main Body (w/o Power Back Door System)
    Tester Display Measurement Item/Range Normal Condition Diagnostic Note
    Back Door Courtesy SW Back door courtesy light switch signal/ON or OFF

    ON: Back door open

    OFF: Back door closed

    		 -