Click here

LEXUS PARKING ASSIST-SENSOR SYSTEM (w/ Side Monitor System), Diagnostic DTC:C1AE2

Click here
Click here Click here
DTC Code DTC Name
C1AE2 Front Left Center Sensor
Click here

DESCRIPTION

The No. 1 ultrasonic sensor (front left center sensor) is installed on the front bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor (front left center sensor). If the No. 1 ultrasonic sensor (front left center sensor) has an open circuit or other malfunction, it will not function normally.

DTC No. DTC Detection Condition Trouble Area
C1AE2 A malfunction of the No. 1 ultrasonic sensor (front left center sensor).

  • No. 1 ultrasonic sensor (front left center sensor)

  • Parking assist ECU
Click here

INSPECTION PROCEDURE

Note:

  • If DTCs are output after repairs, turn the engine switch on (IG) and turn the LEXUS parking assist-sensor system on. Then clear the DTCs (Click here).

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems may be needed (Click here).

Click here

PROCEDURE


  1. Click here

    CHECK DTC OUTPUT


    1. Check for DTCs (Click here).

      Result
      Result Proceed to
      Only DTC C1AE2 is output A
      DTC C1AE2 and C1AEC are output B
      No DTCs are output C

  2. Click here

    REPLACE NO. 1 ULTRASONIC SENSOR (FRONT LEFT CENTER SENSOR)


    1. Replace the No. 1 ultrasonic sensor (front left center sensor) with a known good one (Click here).

      Tip:

      All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.


  3. Click here

    CHECK DTC OUTPUT


    1. Clear the DTCs (Click here).

    2. Check for DTCs (Click here).

      Result
      Result Proceed to
      DTC C1AE2 is output A
      No DTCs are output B

  4. Click here

    REPLACE PARKING ASSIST ECUClick here

  5. Click here

    GO TO DTC (C1AEC)Click here

  6. Click here

    USE SIMULATION METHOD TO CHECKClick here

  7. Click here

    END