NOISE FILTER INSTALLATION


  1. INSTALL RADIO SETTING CONDENSER


    1. A019MPE

      Engage the claw to install a new terminal cover to wire harness.

    2. A019KUQ

      Engage the 3 claws to install the new terminal cover with wire harness to a new condenser.

    3. Engage the clamp to temporarily install the new radio setting condenser with wire harness to the back door.

    4. Install the new radio setting condenser with the bolt.

      Torque:
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }

  2. INSTALL BACK DOOR TRIM PANEL ASSEMBLY


    1. A019LDRE01
      Text in Illustration
      *1 2-piece Type Clip

      Engage the 2 claws and 16 clips to install the back door trim panel assembly.

    2. Install the 2 screws.

  3. INSTALL BACK DOOR SERVICE HOLE COVER RH


    1. A019P9A

      Engage the 5 claws to install the back door service hole cover RH.

  4. INSTALL BACK DOOR SERVICE HOLE COVER LH


    1. A019NI2

      Engage the 5 claws to install the back door service hole cover LH.

  5. INSTALL BACK DOOR UPPER TRIM COVER RH


    1. A019L37

      Engage the 2 claws to install the back door upper trim cover RH.

  6. INSTALL BACK DOOR UPPER TRIM COVER LH


    1. A019NIZ

      Engage the 2 claws to install the back door upper trim cover LH.

  7. INSTALL NO. 2 ROOM LIGHT ASSEMBLY


    1. Connect the connector.

    2. A019KWD

      Engage the claw to install the No. 2 room light assembly.

  8. INSTALL BACK DOOR LOCK COVER


    1. A019M2K

      Engage the 4 claws to install the back door lock cover.

  9. INSTALL DOOR PULL HANDLE WITH SWITCH (w/ Power Back Door)


    1. Connect the connector.

    2. A019LWL

      Engage the 6 claws to install the door pull handle with switch.

  10. INSTALL BACK DOOR FINISH COVER RH (w/o Power Back Door)


    1. A019O6R

      Engage the 6 claws to install the back door finish cover RH.

  11. INSTALL BACK DOOR TRIM BASE (w/ Power Back Door)


    1. A019N4R

      Engage the 4 claws to install the back door trim base.

  12. INSTALL BACK DOOR FINISH COVER LH (w/o Power Back Door)


    1. A019OK7

      Engage the 6 claws to install the back door finish cover LH.

  13. INSTALL TONNEAU COVER SUB-ASSEMBLY