NOISE FILTER INSPECTION


  1. INSPECT RADIO SETTING CONDENSER


    1. With the radio setting condenser installed, check that there is no looseness or other abnormalities.

    2. Remove the bolt.

    3. Disengage the 2 clamps and disconnect the radio setting condenser with wire harness from the vehicle body.

    4. A019M22E01
      Text in Illustration
      *a Radio Setting Condenser

      Measure the resistance of the radio setting condenser according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (+B) - 2 (GND)

      • Engine switch off

      • High mounted stop light off

      • Window defogger off

      • Luggage compartment room light off

      		 10 kΩ or higher
      3 - Body ground Below 1 Ω
      Standard Voltage
      Tester Connection Condition Specified Condition
      1 - Body ground

      • Engine switch on (IG)

      • High mounted stop light off

      • Window defogger off

      • Luggage compartment room light off

      		 Below 1 V
      1 - Body ground

      • Engine switch on (IG)

      • High mounted stop light on

      • Window defogger on

      • Luggage compartment room light on

      		 11 to 14 V