Click here

REAR SEAT ENTERTAINMENT SYSTEM Display Signal Circuit between Navigation Receiver Assembly and Multi-display Controller

Click here
Click here Click here
DTC Code DTC Name
  Display Signal Circuit between Navigation Receiver Assembly and Multi-display Controller
Click here

DESCRIPTION

This is the display signal circuit from the multi-media module receiver assembly to the multi-display controller sub-assembly.

Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY - MULTI-MEDIA MODULE RECEIVER ASSEMBLY)


    1. Disconnect the G39 multi-media module receiver assembly connector.

    2. Disconnect the G46 multi-display controller sub-assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G46-4 (NTS4) - G39-1 (NTSO) Always Below 1 Ω
      G46-5 (SGN4) - G39-2 (NTSG) Always Below 1 Ω
      G46-16 (SLD4) - G39-3 (SLD2) Always Below 1 Ω
      G46-4 (NTS4) - Body ground Always 10 kΩ or higher
      G46-5 (SGN4) - Body ground Always 10 kΩ or higher
      G46-16 (SLD4) - Body ground Always 10 kΩ or higher

  2. Click here

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

  3. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR