AUDIO AND VISUAL SYSTEM (w/ Multi-display), Diagnostic DTC:B1579

DTC Code DTC Name
B1579 Voice Recognition Microphone Disconnected

DESCRIPTION

The radio receiver assembly and map light assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines.

This DTC is stored when a microphone connection detection signal line is disconnected.

DTC No. DTC Detection Condition Trouble Area
B1579 Telephone microphone signal is lost.

  • Map light assembly

  • Telephone microphone assembly

  • Radio receiver assembly

  • Harness or connector

WIRING DIAGRAM

A019M9LE41

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT RADIO RECEIVER ASSEMBLY


    1. A019NAHE31
      Text in Illustration
      *a

      Component with harness connected

      (Radio Receiver Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G38-19 (MIN-) - Body ground Always Below 1 Ω

    NG

    REPLACE RADIO RECEIVER ASSEMBLY Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - MAP LIGHT ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY))


    1. Disconnect the G38 radio receiver assembly connector.

    2. Disconnect the T10 map light assembly (telephone microphone assembly) connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G38-6 (SNS2) - T10-36 (SNS2) Always Below 1 Ω
      G38-19 (MIN-) - T10-35 (MCO-) Always Below 1 Ω
      G38-6 (SNS2) - Body ground Always 10 kΩ or higher
      G38-19 (MIN-) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. INSPECT MAP LIGHT ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY)


    1. A019P11E09
      Text in Illustration
      *a

      Component without harness connected

      (Map Light Assembly (Telephone Microphone Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      T10-36 (SNS2) - T10-35 (MCO-) Always Below 1 Ω

    NG

    REPLACE TELEPHONE MICROPHONE ASSEMBLY Click here

    OK

    REPLACE RADIO RECEIVER ASSEMBLY Click here

  4. REPLACE TELEPHONE MICROPHONE ASSEMBLY


    1. Replace the telephone microphone assembly Click here.

    2. Clear the DTCs Click here.

    3. Recheck for DTCs and check that no DTCs are output.

      OK
      No DTCs are output.

    NG

    REPLACE MAP LIGHT ASSEMBLY Click here

    OK

    END