BRAKE PEDAL LOAD SENSING SWITCH ON-VEHICLE INSPECTION


  1. REMOVE BRAKE PEDAL LOAD SENSING SWITCH


    1. Disconnect the brake pedal load sensing switch connector.

    2. Measure the resistance according to the value(s) in the table below.

      A019K2AE01

      Note


      • Do not remove the brake pedal load sensing switch from the brake pedal sub-assembly.

      • When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal sub-assembly.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      2 (FSW+) - 1 (GND)

      Brake pedal load sensing switch OFF

      (Brake pedal depressed)

      		 950 to 1050 Ω
      2 (FSW+) - 1 (GND)

      Brake pedal load sensing switch ON

      (Brake pedal released)

      		 203 to 223 Ω