WIPER SWITCH REMOVAL


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.

  2. REMOVE STEERING COLUMN COVER


    1. A019P5N

      Turn the steering wheel assembly to the right and remove the screw as shown in the illustration.

    2. A019NVX

      Turn the steering wheel assembly to the left and remove the screw as shown in the illustration.

    3. Disable the auto tilt away function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the auto tilt away function is enabled or disabled) in order to restore the current setting after finishing this operation.

      Tech Tips

      Performing the above operation disables the auto tilt away function when the engine switch is turned off.

    4. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and upper the steering column assembly.

    5. Turn the engine switch off and disconnect the cable from the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    6. A019P64

      Remove the screw.

    7. Disengage the 2 claws and remove the lower steering column cover.

      Note

      Do not damage the tilt and telescopic switch.

    8. A019OM3

      Disengage the claw.

    9. A019LQG

      Disengage the 4 clips and 2 guides to remove the upper steering column cover as shown in the illustration.

  3. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    1. A019N8T

      Disconnect the connector.

    2. Disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.

      Note

      If the claw is pushed with excessive force, it may break.