REAR WIPER RUBBER REPLACEMENT


  1. REMOVE REAR WIPER BLADE


    1. Turn the engine switch on (IG).

    2. Turn the rear wiper switch on.

    3. A019LVWE01
      Text in Illustration
      *1 Protective Tape

      Turn the engine switch off when the wiper arm stops at the position shown in the illustration.

      Standard Clearance
      Area Measurement
      A 280 mm (11.02 in.)
      B 265 mm (10.43 in.)

      Tech Tips

      It is easier to stop the wiper blade at the position indicated in the illustration while the wiper blade is returning to the original position.

    4. Apply protective tape to the areas shown in the illustration.

    5. A019LU4

      Raise the wiper blade to the position where the claw detaches with a click sound as shown in the illustration.

      Note


      • Make sure that the wiper arm does not interfere with the rear spoiler.

      • If the wiper arm does interfere with the rear spoiler, perform steps (a) through (c) again, making sure to stop the wiper arm in a near-vertical position.

      • Be careful not to damage the claw.

    6. A019LZR

      Pull the wiper blade straight toward the left side of the vehicle to remove it from the wiper arm.

      Note

      Do not lower the wiper arm with the wiper blade removed. The arm tip may damage the back door glass surface.

  2. REMOVE REAR WIPER RUBBER


    1. A019NSZE01

      Lift and pull the end of the wiper rubber protrusion from the blade stopper as shown in the illustration.

      Note

      Do not forcibly pull out the wiper rubber. The backing plates will be deformed or the blade claws will be damaged.

      Tech Tips

      Lightly pushing the rubber in the middle will allow it to be removed more easily.

    2. Remove the rear wiper rubber backing plates.

  3. INSTALL REAR WIPER RUBBER


    1. A019NJTE02

      Install the rear wiper rubber backing plates as shown in the illustration.

      Note

      Install the backing plates facing the correct direction.

    2. Insert the wiper rubber from the front end of the wiper blade to the rear end through the second claw.

    3. A019LK8E01

      After pushing the wiper rubber through the rear end claw, allow it to stick out from the rear end stopper.

    4. A019K4QE01

      Slide the wiper rubber through the front end claw.

  4. INSTALL REAR WIPER BLADE


    1. A019LF6

      Push the wiper blade straight toward the right side of the vehicle to install it to the wiper arm.

      Note

      Make sure that the wiper arm does not interfere with the rear spoiler.

    2. A019MHO

      Engage the claw to install the rear wiper blade as shown in the illustration.

      Note

      Be careful not to damage the claw.