CONTROL VALVE ASSEMBLY (for Front Side) REMOVAL

CAUTION:

Be sure to read Precaution thoroughly before servicing Click here.

Note


  • Before removal, make sure to disable vehicle height control by pressing the absorber control switch (height control OFF switch) and confirming that the height control OFF indication is displayed on the meter.

  • Check the safety of your surroundings and use caution when disconnecting each height control valve air tube as the air in each pneumatic cylinder will be discharged and the vehicle body will lower.

  • This operation takes out the air from the front shock absorber, therefore never rotate the lower part of the absorber by turning the steering wheel etc.


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT BUMPER ASSEMBLY

    for Standard: Click here

    for Sport package: Click here

  4. REMOVE NO. 1 HEIGHT CONTROL VALVE SUB-ASSEMBLY


    1. A019L18

      Disconnect the connector and disengage the clamp.

    2. A019PA4

      Remove the 3 holders and disconnect the 3 height control tubes.

      Tech Tips

      For the disconnecting procedure of the tube (type 3), refer to Precaution of Suspension Control System Click here.

    3. A019OPE

      Remove the 2 bolts and No. 1 height control valve sub-assembly.