ACTIVE TORQUE CONTROL 4WD SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use the following procedure listed to troubleshoot the Active Torque Control 4WD system.

  • *: Use the intelligent tester.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. INSPECT BATTERY VOLTAGE

    Standard voltage
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT

  3. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

    2. Check for DTCs Click here.

      Result
      Result Proceed to
      CAN DTC is not output A
      CAN DTC is output B

      B

      Go to CAN COMMUNICATION SYSTEM
      A

  4. CHECK DTC*


    1. Check for DTCs Click here.

    2. Clear the DTCs.

    3. Recheck for DTCs.

      Result
      Result Proceed to
      DTC does not reoccur A
      DTC does reoccur B

      B

      GO TO STEP 7
      A

  5. PROBLEM SYMPTOMS TABLE

    Result
    Result Proceed to
    Fault not listed in problem symptoms table A
    Fault listed in problem symptoms table B

    B

    GO TO STEP 7
    A

  6. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Terminals of ECU Click here.

    2. Data List / Active Test Click here.


      NEXT

  7. REPAIR OR REPLACE


    NEXT

  8. CONFIRMATION TEST


    NEXT
    END