TCM INSTALLATION

INSTALL TCM
1. Install the TCM to the transaxle.
2. Install and tighten the 2 bolts in the order shown in the illustration.
  
  Torque:
  
  11 N*m { 115 kgf*cm, 8 ft.*lbf }
3. Connect the connector to the TCM.
4. Turn the lock lever and secure the connector with the lock lever.
INSTALL AIR CLEANER BRACKET
1. Install the air cleaner bracket with the 3 bolts.
  
  Torque:
  
  Bolt A
  
  13 N*m { 133 kgf*cm, 10 ft.*lbf }
  
  Bolt B
  
  5.5 N*m { 56 kgf*cm, 49 in.*lbf }
2. Engage the clamp and connect the engine wire.
INSTALL BATTERY
1. Install the battery and battery tray.
2. Install the battery clamp with the bolt and nut.
  
  Torque:
  
  5.4 N*m { 55 kgf*cm, 48 in.*lbf }
3. Connect the positive (+) cable to the positive (+) battery terminal.
  
  Torque:
  
  6.4 N*m { 65 kgf*cm, 57 in.*lbf }
INSTALL INLET NO. 1 AIR CLEANER
1. Install the No. 1 air cleaner inlet with the bolt.
  
  Torque:
  
  8.0 N*m { 82 kgf*cm, 71 in.*lbf }
INSTALL INLET NO. 2 AIR CLEANER
1. Install the No. 2 air cleaner inlet with the 2 bolts.
  
  Torque:
  
  8.0 N*m { 82 kgf*cm, 71 in.*lbf }
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL COOL AIR INTAKE DUCT SEAL
1. Install the cool air intake duct seal with the 6 clips.
INSTALL ENGINE ROOM SIDE COVER LH
1. Engage the guide.
2. Install the engine room side cover LH with the 4 clips.
INSTALL ENGINE ROOM SIDE COVER
1. Engage the guide.
2. Install the engine room side cover with the 4 clips.
CHECK AUTOMATIC TRANSAXLE SYSTEM

Note

If automatic transmission parts have been replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary Click here.