TCM REMOVAL

Note

If automatic transmission parts are replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary Click here.


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. REMOVE ENGINE ROOM SIDE COVER


    1. A019LQM

      Remove the 4 clips.

    2. Disengage the guide and remove the engine room side cover.

  3. REMOVE ENGINE ROOM SIDE COVER LH


    1. A019K5V

      Remove the 4 clips.

    2. Disengage the guide and remove the engine room side cover LH.

  4. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A019MCL

      Remove the 6 clips and cool air intake duct seal.

  5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE INLET NO. 2 AIR CLEANER


    1. A019ODB

      Remove the 2 bolts and No. 2 air cleaner inlet.

  7. REMOVE INLET NO. 1 AIR CLEANER


    1. A019LTK

      Remove the bolt and No. 1 air cleaner inlet.

  8. REMOVE BATTERY


    1. Disconnect the positive (+) cable from the positive (+) battery terminal.

    2. A019LTJ

      Loosen the nut, and remove the bolt from the battery clamp.

    3. Remove the battery and battery tray.

  9. REMOVE AIR CLEANER BRACKET


    1. A019K5J

      Disengage the clamp and disconnect the wire harness.

    2. Remove the 3 bolts and air cleaner bracket.

  10. REMOVE TCM


    1. A019ONV

      Turn the lock lever and disconnect the connector from the TCM.

    2. A019L5W

      Remove the 2 bolts and TCM from the transaxle.