OIL PUMP REASSEMBLY


  1. INSTALL FRONT OIL PUMP OIL SEAL


    1. A019KADE01

      Coat the lip of a new front oil pump oil seal with a small amount of MP grease.

    2. Using SST and a hammer, install the front oil pump oil seal to the front oil pump body sub-assembly.

      SST
      09350-32014   ( 09351-32140 )

      Note

      The seal end should be level with the outer edge of the front oil pump body sub-assembly.

  2. INSTALL FRONT OIL PUMP BODY O-RING


    1. A019NTW

      Coat a new front oil pump body O-ring with ATF and install it to the front oil pump body sub-assembly.

      Note

      Ensure that the O-ring is not twisted.

  3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    1. A019PLY

      Coat the front oil pump driven gear with ATF and install it to the front oil pump body sub-assembly with the marked side up.

  4. INSTALL FRONT OIL PUMP DRIVE GEAR


    1. A019K2J

      Coat the front oil pump drive gear with ATF, and install it to the front oil pump body sub-assembly with the marked side up.

  5. INSTALL STATOR SHAFT ASSEMBLY


    1. A019O9EE01

      Align each knock pin of the stator shaft assembly with the holes in the front oil pump body sub-assembly and install the stator shaft assembly to the front oil pump body sub-assembly with the 16 "TORX" bolts.

      Bolt Length
      Bolt Length [mm (in.)]
      A 14 (0.551)
      B 26 (1.02)

    2. Using a T30 "TORX" socket wrench, tighten the 16 "TORX" bolts.

      Torque:
      9.3 N*m  { 95 kgf*cm, 82 in.*lbf }

  6. INSPECT FRONT OIL PUMP ASSEMBLY


    1. A019OOP

      Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

      Note

      Be careful not to damage the oil seal lip.